Includes two L293D Quad H-Bridges chipset that can provide 0.6A per bridge (1.Support motors operating between 4.5V to 25V DC Motor power supply can be configured to source from the motor power terminal block or from the Arduino’s VIN pin.Support up to 4 bi-directional DC motors with individual 8-bit speed selection, and up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.It supports DC motors & Stepper motors with microstepping as well as stacking-support. Servo power supply can be configured to source from the servo power terminal block or from the Arduino’s 5V pin This is the library for the Adafruit Motor Shield V2 for Arduino.You can see a 74HC595 shift register and two L293D motor drivers. The servo power supply and motor power supply can be configured to source from an individual terminal block or from the Arduino board providing flexibility to your project. Further, it drives the DC motor using L293D and servo motors with Arduino pin9 and pin10. Servo header and terminal blocks are provided for easy connection to motor. It supports up to 2 servo motors and 4 bi-directional DC motors, or 2 servo motor and 2 stepper motors. L293D Motor Driver Shield Or Servo Shield For Arduino 299.00 188.00 PRODUCT OVERVIEW Capable of Driving 2 Stepper or DC motor Bidirectional Control Motor Voltage rating: 4.5V to 25V Can also drive servo motor High efficiency and simple usage Continuous Output current 1. The Motor and Servo Shield for Arduino can plug directly onto the Arduino and Arduino compatible boards. Brings out the Arduino’s reset button to the top of the shield.Individual LED indicator for motor power supply state and servo power supply state.Integrated pull down resistor to keep motor disable during start up.Provides connectors to support 2 servos.Mate with Arduino and Arduino compatible boards.To control the servo motor, use: Pins 2, 9, and 10. In such cases, six analog pins including pins 2 and 13 remain free for use. The shield can be fitted on top of the Arduino board. In the pdf diagram, the black wire brown wire. Arduino’s L293D motor driver shield is compatible with Arduino Mega and UNO. Connect the brown wire (Ground wire) of the servo to the GND (ground) pin of the Arduino Uno.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |